1. No category

2.000 50.80
.766 19.47
.548 13.92
.462 11.72
0 0.00
.003 0.06
REVISION
.150 3.81
R.063 - .087
.024 0.61
3X .250 6.35
C1
.012 0.30
.025 0.64
.245 6.22
UNLESS OTHERWISE SPECIFIED,
DIMENSIONS ARE IN INCHES.
TOLERANCES ARE:
DECIMALS
NOTES:
1. COMPONENT IS NON-STANDARD.
2. C REPRESENTS A CRITICAL DIMENSION.
.089 2.26
1.125[28.58]
R.250 6.35
ANGLES
.XX: .01 [.3]
2
.XXX: .005 [.13]
.XXXX: .0020 [.051]
PROPRIETARY NOTE
THIS DOCUMENT CONTAINS INFORMATION
CONFIDENTIAL AND PROPRIETARY TO
SAMTEC, INC. AND SHALL NOT BE REPRODUCED
OR TRANSFERRED TO OTHER DOCUMENTS OR
DISCLOSED TO OTHERS OR USED FOR ANY
PURPOSE OTHER THAN THAT WHICH IT WAS
OBTAINED WITHOUT THE EXPRESSED WRITTEN
CONSENT OF SAMTEC, INC.
DO NOT SCALE DRAWING
MATERIAL: 17-4 STEEL
OPTIONAL: 15-5 STEEL
HEAT TREAT: H1150
F:\dwg\SW\Exisprod\Compnt\Rf\CAT-EX-SCC-01.SLDDRW
SHEET SCALE: 1:1
520 PARK EAST BLVD, NEW ALBANY, IN 47150
PHONE: 812-944-6733
FAX: 812-948-5047
e-Mail: [email protected]
code: 55322
DESCRIPTION:
DWG. NO.
CUSTOM HDR COMPONENT
CAT-EX-SCC-01
BY: RMSANTOS
02/07/07 SHEET 1 OF 1